You supposedly get past the initial shock, much like you would eventually be able to drive a car while being suspended upside down from the ceiling. The learning curve is steep and doing your first schematics is an exercise in frustration.
It is hard to find adequate words to describe how un-intuitive and horrific the UI is to use. The user interface paradigms do not follow any usual norms, but are instead likely made up by the first developer of the software somewhere in the nineties. What the recommenders don’t usually mention is that Eagle CAD’s abysmal usability. Also, a lot of open hardware projects share their schematics in Eagle format, and many PCB fabrication shops accept Eagle files directly without conversion to Gerber format. The main reasons are probably the rather reasonable pricing and large existing userbase. The electronics CAD software, the most often recommended software for beginners is Eagle CAD. Let’s get started! Why DipTrace and not Eagle CAD (or some other brand)?
Additionally, I’m showing how to use DipTrace’s powerful facilities to create new components in literally few minutes. The circuit I’m doing is a simple ATtiny2313 breadboard header that integrates an ISP programming header, a few capacitors, a reset pullup resistor and a clock crystal, eliminating the need to wire these things every time I start a new project. In this short tutorial, I’ll show how to create a simple schematic using DipTrace, an excellent electronics CAD package that has a free version as well as inexpensive entry-level commercial and non-profit licenses. However, computer aided design (CAD) software does have it’s advantages, allowing easy modifications, sharing and later PCB creation.
If you have a steady hand and lots of paper to spare, the first option is to draw the schematics on paper. Sooner or later there comes a point in your electronics career where it would be nice to have a schematic for the project you are doing.
0 kommentar(er)
